High Quality AAC Block Equipment AAC Block Plant Autoclaved Aerated
What is AAC (Autoclaved Aerated Concrete) ?
AAC block (autoclaved aerated concrete block), also called Light
Block which through the process of batching, pouring, pre-curing,
cutting, autoclaving, separating and packing to make into the final
products. AAC block is new type & environmental construction
material and widely used for industry and civil building
construction. It has light ,keeping temperature , Environmental
protection,can’t burn and other advantages. It has a wide prospect
of market.it is the main building material in the future. AAC block
can be made into many kinds of bricks(for
example:600×200×100,80×80×180,240×115×53,600×200×125),they could be
used industry building and common building. AAC Block is the most
mature technology of production and application in the worldwide
nowadays. As normally, concrete density is usually 1600-2400kg/m3,but aerated concrete are 500kg/m3,600kg/m3,700kg/m3.It has not the big grain and use silicon material (for example:
fly ash,sand,stone dust and others ),through making the material
small for example sand, they can be used directly if has enough
degree of small (for example fly ash, Mixing calcium material lime,
cement, water to a special ratio, then add the aluminum dust and
the additive, then Make the aluminum dust and the special ratio
have a Chemical reflect. then produce Hydrogen to make the concrete
slop to expanding or swell and foam. Next put them into the curing
room to concreting cutting steaming curing, At last, there will
become the light brick and the porous rate is 70-80%.
1. The machine structure is simple and practical, the maintenance
2. The cake is sideward, so the width of the whole cake is 600mm,
and the height is 1200mm. Steel wires for cutting is short, which
is also difficult to rupture and float. It is high in cutting
3. The vertical cutting device is fixed. Crosscut device cuts the
cake vertically by steel wires. It shortens the cutting steel wires
length, guarantee precision of cutting;
4. This machine cuts the green cake in Hexahedron-type, so the
products quality wont be influenced by the distortion of the mould;
5. Cylinder Tension, which supply gas to each wire respectively;
6. Avoiding the wires being stretched off by using a special
7. Life of the wire can extend (Usually 10 days, Now 20 days);
8. Operating it in use of the computer touch panel, realize
separation of Man-Machine.
1. Production Line Design.
Including: drawing of plant working process,drawing of land
construction,drawing of power working, drawing of driving force for
working,drawing of anti-dust,drawing of water supply and drainage
and drawing of air pipeline construction.
2. Technical Guidance of Building Factory
Including consultation of facility, Equipment installation guide,
constitution the production preparation, etc.
3. Providing the technical information of setting up factory
Including: part of the factory management system, all posts
accountability of production line, process rules, safety rules,
setting a quota of staff and posts, pre-production tools directory,
laboratory instruments, product catalogs, and test methods.